Laser tracker kinematic error model formulation and subsequent verification under real working conditions
Resumen: A kinematic model of the Laser Tracker (LT) based on the Denavit-Hartenberg method has been developed. In this model, error matrices have been included with error parameters for linear and rotary joints. The calibration method is based on the measurement of a mesh of reflectors measured by a LT from different positions. Error parameters are calculated knowing that distances between every pair of reflectors is the same regardless the LT position. The absence of nominal data prevents us from knowing the calibration behaviour and its suitability. Although synthetic data tests show a good accuracy improvement, it is not possible to know if this will work with under real working conditions. An experiment has been made to check the calibration procedure. A set of 17 reflectors have been placed on a Coordinate Measuring Machine (CMM) and have been measured by a LT from 5 different positions. Reflector positions have also been measured with the CMM to calculate the initial errors. With LT measurements we calculate the error parameters. LT measurements are recalculated considering the kinematic error model and compared with the CMM measurements to get the residual error. Two errors have been calculated; distances error between reflectors and their position error compared with CMM data.
Idioma: Inglés
DOI: 10.1016/j.proeng.2015.12.561
Año: 2015
Publicado en: Procedia Engineering 132 (2015), 788-795
ISSN: 1877-7058

Factor impacto SCIMAGO: 0.239 - Engineering (miscellaneous)

Tipo y forma: Artículo (Versión definitiva)
Área (Departamento): Proy. investigación HHA (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)


Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2021-01-21-11:18:45)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2017-06-14, última modificación el 2021-01-21


Versión publicada:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)