The use of a Laser Tracker and a Self-centring Probe for Rotary Axis Verification
Resumen: This paper presents a small collection of tests related with the analysis of a rotary axis according to ISO 230-7 but introducing two alternative equipments briefly explaining each method. The disadvantages of the methods in which the movement of a rotary axis engages the translational axes of a Machine Tool are expressed, which leads to the proposed study. The errors of a rotary axis are described as established in standards and the measurement procedures carried out in the tests for verification of a rotary indexing table, based on the use of a self-centring probe and a laser tracker, are explained. Also, the necessary elements setup for measurement are described. Then, the followed calculation process of the measured errors is explained in detail. Finally, the results of the most significant errors obtained from the test measurements are presented.
Idioma: Inglés
DOI: 10.1016/j.proeng.2015.12.556
Año: 2015
Publicado en: Procedia Engineering 132 (2015), 748-755
ISSN: 1877-7058

Factor impacto SCIMAGO: 0.239 - Engineering (miscellaneous)

Tipo y forma: Article (Published version)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)
Exportado de SIDERAL (2021-01-21-11:00:11)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
articulos



 Notice créée le 2016-01-27, modifiée le 2021-01-21


Versión publicada:
 PDF
Évaluer ce document:

Rate this document:
1
2
3
 
(Pas encore évalué)