Universidad de Zaragoza Repository

Resumen: This paper presents a small collection of tests related with the analysis of a rotary axis according to ISO 230-7 but introducing two alternative equipments briefly explaining each method. The disadvantages of the methods in which the movement of a rotary axis engages the translational axes of a Machine Tool are expressed, which leads to the proposed study. The errors of a rotary axis are described as established in standards and the measurement procedures carried out in the tests for verification of a rotary indexing table, based on the use of a self-centring probe and a laser tracker, are explained. Also, the necessary elements setup for measurement are described. Then, the followed calculation process of the measured errors is explained in detail. Finally, the results of the most significant errors obtained from the test measurements are presented.
Idioma: Inglés
DOI: 10.1016/j.proeng.2015.12.556
Año: 2015
Publicado en: Procedia Engineering 132 (2015), 748-755
ISSN: 1877-7058
Factor impacto SCIMAGO: 0.239 - Engineering (miscellaneous)

Tipo y forma: Article (Published version)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)

You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. You may not use the material for commercial purposes. If you remix, transform, or build upon the material, you may not distribute the modified material.

Exportado de SIDERAL (2021-01-21-11:00:11)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Articles